shear stress
英 [ʃɪə(r) stres]
美 [ʃɪr stres]
网络 剪切应力; 剪应力; 切应力; 剪應力; 剪切力
双语例句
- Shear stress arises from forces that are parallel to the plane of the cross section.
切应力由平行于截面的力引起。 - Tension strength and shear stress distribution of GFRP strengthening concrete beam
加固混凝土梁的GFRP板抗拉强度与界面切应力 - A calculation model for the interfacial shear stress of the reinforced concrete beam strengthened with prestressed CFRP sheets was built based on the elasticity theory after releasing and loading.
采用弹性理论方法，建立了预应力碳纤维布加固钢筋混凝土梁在放张和承载后界面剪应力的理论计算模型。 - Wind tunnel experiments show that the developed sensor can measure wall shear stress with high repeatability.
结合风洞试验验证了该传感器测量壁面剪应力的有效性，并且获得了较好的测量重复性。 - A stress-strain diagram can be plotted using shear stress and shear strain.
应力-应变图可以用来表现剪切应力与剪切变形。 - Draw the element for maximum shear stress and mark values of all stresses.
画出最大剪应力的单元体并标出全部应力值。 - The stress-stain curve shows the strain-hardening characteristic without initial shear stress.
当不存在初始剪应力时，应力–应变关系表现为硬化型曲线； - It can achieve lowest shear stress and the maximum uniformity for solid suspension without any internal agitator.
其具有低剪切应力无搅拌混合和达到固体颗粒的均匀悬浮。 - Effect of initial shear stress on static and dynamic behavior of soft clay under cyclic loading
初始剪应力对饱和软粘土静、动力学性能影响&试验研究 - The dependence of the solution shear viscosity on the shear stress, temperature and cellulose material content was investigated.
考察了剪切力、温度、纤维素原料质量分数对溶液表观粘度的影响。 - When the bond is destroyed the shear stress distribution on the bolt side can be expressed by parabolic curve.
而对于锚杆与砂浆的粘结遭到破坏的区段，采用抛物线来拟合。 - Essentially the main mechanism of deformation and failure of rock mass induced by earthquake is the coupling effect of shear stress and excess static pore water pressure accumulation.
地震作用导致岩体变形破坏的主要机制是剪应力积聚和超静孔隙水压力累积效应的耦合作用。 - The computation results show that the external counterpulsation can effectively change the blood vessel pipe_ wall shear stress.
计算结果表明，体外反搏可以明显有效地改变血管壁剪切应力。 - In the experiments, a small-amplitude sine wave of displacement is modulated to shear loading to study the effects of shear stress perturbation on stick-slip instability.
实验中通过在剪切方向上叠加正弦波状的位移扰动，研究了剪应力扰动对断层粘滑失稳的影响。 - The experiment and comparison results show that the ultimate shear stress, cohesion and angle of internal friction decrease along with the broadening of water content in the expansive soil.
试验和对比结果表明，膨胀土的极限剪应力、凝聚力和摩擦角都随着含水率的增大而减小； - Viscoelastic Finite Element Analysis of Shear Stress on Asphalt Pavement Surface
沥青路面面层剪应力的粘弹性有限元分析 - Cohesion is best defined in terms of the plot of shear stress versus normal stress given in Figure 9.
粘结力最好根据图9中剪切应力和法向应力的关系曲线确定。 - Study on bottom shear stress of laminar boundary layer under the action of random waves;
运用数值模拟的方法对线性波作用下的层流边界层和紊流边界层进行了研究。 - The concept of wave spectrum is applied to the study on bottom shear stress under random wave action.
本文在随机波浪底部剪应力的研究中引入了波浪谱的概念。 - The interfacial shear stress is a constant proportion of the bottom shear.
交界面的剪力与底部剪力之比是常数。 - According to the twin shear stress theory, this paper improves on Duncan Model.
根据双剪应力理论对邓肯模型进行了修正。 - Influence of transverse crack model on shafting's torsional shear stress
轴系横向裂纹模型对其扭转剪应力的影响 - Higher initial normal stresses offer higher shear stress with the same horizontal displacement.
初始法向应力越大，相同剪切位移对应剪应力越大； - The analytical results show that the failure plane by anisotropic strength criterion cannot coincide with the maximum shear stress plane.
分析结果表明，岩体在各向异性强度准则下的破坏面不一定与最大剪应力面重合； - Geogrid reinforcement can improve maximal compressive stress distribution, and decrease shear stress on the surface of soil foundation.
土工格栅加筋改善地基表面的最大压应力分布，减小传递到地基表面的剪应力； - Shear stress would be released at the damaged points and transfer to the crack tips.
损伤的产生使得应力在损伤点得以释放，并转移到其前端未损伤的接触单元上。 - The shear stress and apparent viscosity of the masterbatch decreased with the increase of the shear rate and temperature.
随着剪切速率的增加，温度升高，剪切应力会降低，母粒的表观黏度也随之降低。 - As to the sediment used in the papers experiment, only the bed shear stress increases to1.
对于本系列试验所用泥沙，只有床面切应力大于初始粗化床面切应力的1。 - Results showed that the longitudinal stress obtained from the expanded beam theory was satisfied, but the precision for deflection and shear stress calculation should be improved.
结果表明，按扩展梁理论设计虽然能够得到精度较好的纵向应力结果，但挠度和剪切应力计算精度有待提高； - The distribution of normal stress in fiber and interfacial shear stress were obtained as well as the axial pull-out force.
拔出为例，对橡胶-纤维复合材料不同温度下的界面力学性能进行了数值分析，得到了相应的应力场分布和拔出载荷的变化。